Review- Friction and Wear on Journal Bearings used in Heavy Machinery

V.Raja kiran Kumar, Akula Sai Bhargav, V Mukesh Reddy


It is verifiable truth that interfacing bar is the imperative middle of the road part between the cylinder and the Crankshaft. Its essential capacity is to transmit the push and draw from the cylinder stick to the wrench stick, accordingly changing over the responding movement of the cylinder into turning movement of the wrench. Existing Bearing of associating pole is fabricated by utilizing non ferrous materials like Gunmetal, Phosphor Bronze and so on.. This paper portrays the tribological conduct examination for the ordinary materials i.e. Metal and Gunmetal and additionally New non metallic material Cast Nylon. Contact and Wear are the most vital parameters to choose the execution of any bearing. In this paper endeavor is made to check major tribological parameters for three material and attempt to recommend better new material contrasted with customary existing material. It could enable us to limit the issue of taking care of materials to like Lead , Tin, Zinc etc.After Test on wear machine we found that Cast Nylon contrasted with Brass and Gunmetal for the same working and greasing up condition, have less estimation of coefficient of erosion which help us to limit control lost because of grating and help with expanding general motor effectiveness of the motor.



Tribology, Friction, Wear, Cast Nylon, Artificial cooling, engine efficiency.

Copyright (c) 2018 Edupedia Publications Pvt Ltd

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.


All published Articles are Open Access at 

Paper submission: