Analytical Investigation of Material Removal Rate During Wedm and The Effect of Process Parameters On It

Abstract

For any machining process and, particularly, in process related to Wire Electrical Discharge Machining (WEDM) the right selection of machining conditions is one of the most important aspects to be taken into consideration. WEDM is capable of machining of geometrically complex shapes or material components having higher hardness, that are precise and very difficult-to-machine such as composites, super alloys heat treated tool steels, ceramics, heat resistant steels, carbides etc. This investigation discusses the effects of machining parameters like pulse on time, pulse off time and voltage on the material removal rate of wire electric discharge machining. For this investigation, stainless steel (SS 304) has been used as a work piece and a brass wire and a diffused wire having 0.25 mm diameter is used as tool electrodes. The design of experiment is based on Taguchi Design approach L9 orthogonal array. The results show that, the pulse on time and servo voltage has the highest influence on material removal rate (MRR). As the pulse on time increases, the material removal rate increases. It is also concludes that, with the increase of pulse off time and servo voltage, the material removal rate decreases.